Hitachi Compute Blade 2000 User Manual page 1149

List#1 update end
** << Boot Device List >> (LUN:decimal)
1 - WWPN:XXXXXXXXXXXXXXXX LUN:0000
2 - WWPN:0000000000000000 LUN:0000
3 - WWPN:0000000000000000 LUN:0000
4 - WWPN:0000000000000000 LUN:0000
5 - WWPN:0000000000000000 LUN:0000
6 - WWPN:0000000000000000 LUN:0000
7 - WWPN:0000000000000000 LUN:0000
8 - WWPN:0000000000000000 LUN:0000
change? (y/[n]) -->n
Base Settings is completed
15 When settings are completed, enter the save command to save the settings.
16 Use the exit command to return to the EFI Shell.
17 Execute the reconnect –r command, and then enter the map –r command.
Confirm that the target LU is listed next to the Fibre and its WWN is correct.
Shell> reconnect -r
ReconnectController(X,X,X) : Status = Success
Shell> map -r
Device mapping table
fs0 :Removable BlockDevice - Alias XXXX blk0
blk0 :Removable BlockDevice - Alias XXXX fs0
blk1 :BlockDevice - Alias (null)
Acpi(PNP0A08,0)/Pci(4|0)/Pci(0|2)/Pci(4|1)/Fibre(WwnXXXXXXXXXXXXXXXX, Lun0)
Blk2 :Removable BlockDevice - Alias XXXX fs0
：
Shell>
Displayed details are different depending on the environment.
18 Confirm the settings and then enter the exit command.
1098