Hitachi Compute Blade 2000 User Manual page 1519

Message content LPAR Manager started retrying the setting of TxRate
Level Warning
Explanation Failed to configure TxRate. Try to configure TxRate again.
What to do Wait a while for the retry to finish.
Message content LPAR manager failed to get the firmware version on a NIC
Level Error
Explanation Getting firmware version from NIC device failed.
What to do Restart the LPAR manager. If this action takes no effect, contact the
reseller from which you purchased this equipment or consult
maintenance personnel.
Message content LPAR manager failed to have SR-IOV device enabled.
Level Error
Explanation Detected that different SR-IOV settings exist among ports in the
controller.
What to do Check the SR-IOV setting values of the PCI devices.
Alternatively, make sure that the Personality setting is set to NIC
mode. For details about how to check this setting, see the manual
Hitachi Compute Blade 2000 / 500 Emulex Adapter User's Guide for
Hardware. Note, however, that you cannot change the setting in LP
mode.
To change the setting, change the mode to Basic mode.
Message content
Level Warning
Explanation LPAR manager firmware updating failed.
What to do A screen, showing that LPAR manager firmware update failed, is
displayed. Follow the procedure shown in the screen to handle the
problem.
Message content LPAR manager firmware update finished successfully.
Level Information
Explanation LPAR manager firmware was successfully updated.
What to do None.
Message content LPAR manager firmware update was started.
Level Information
Explanation LPAR manager firmware updating was started.
What to do None.
Message content LPAR manager has successfully imported Time Setting of
Level Information
Explanation BMC time setting has been successfully imported.
What to do None.
configuration.
device.
LPAR manager firmware update failed.
BMC.
1468