Hitachi Compute Blade 2000 User Manual page 619

If you enter E in the ILC command menu and press Enter, the current setting is
displayed. At the prompt, enter an internal network address, and the changed setting
value is displayed. Then a warning message is displayed saying that the management
module will restart after the setting change. A confirmation message appears. At the
prompt, enter Y and press Enter. The internal network setting is saved. Then the
management module will restart. To cancel the setting, enter N and press Enter, or just
press Enter.
(E,[Q]) : E(Enter)
Network address : 192.168.253. 0
([Unchange]) : 192.168.200.0(Enter)
-- Internal network --
Network address : 192.168.200. 0
Subnetmask : 255.255.255. 0
WARNING : If confirm, management module restart and this connect is lost.
Confirm? (Y,[N]) : Y(Enter)
- <Management module0> Restarting
Do not change the internal network address while the server
blade is operating, which causes the management module to
restart. If you do, error events, which have occurred while the
management module is restarting, may not be detected.
When changing the internal address while the server blade
with N+M cold standby enabled is not in operation, make
sure to perform Smart Configure afterwards.
568