Date And Time - Hitachi Compute Blade 2000 User Manual

 Date and time
The following actions are possible in the Date and Time screen.
Displays the RTC time of the current LPAR.

Displays the RTC time when the LPAR is activated or deactivated last.

Displays the RTC time of the LPAR updated last by the guest.

Specifies LPAR's SEL (System Event Log) date and time mode.

Sets LPAR's SEL date and time.

Sets LPAR's SEL time zone.

Sets LPAR manager display time.

Sets LPAR manager system time zone.

Synchronizes RTC time and SEL time to the LPAR manager system time or UTC

time.
Synchronizes LPAR manager system time with NTP servers.

It is recommended that you use NTP for operating LPAR manager with LPAR

manager firmware version 58-7X/78-7X or later.
Use the same time zone for management modules, BMC, and LPAR manager. If

not, the exact time when a failure occurs cannot be found because each clock
shows a different time.
It is recommended that BMC and LPAR manager clocks be synchronized using

the management module.
See Management Module Settings in Chapter 6 >

System Web Console > Time Setting for setting the time
of a management module.
See Server Blade Setup in Chapter 5 > Standard Server

Blade Setup Menu (X55A1/X55A2 Models) or
High-performance Server Blade Settings
(X57A1\X57A2 Models) > BMC Time Settings for setting
the BMC time.
Set the logical SEL (System Event Log) time to each LPAR by which the physical SEL
detected by LPAR manager is reported to each LPAR.
Any values modified on this screen will not be saved automatically in the LPAR manager
System and lost at the LPAR manager boot. Press F9: Save Configuration on the LPAR
manager Menu screen explicitly to save the newly set value. To change the LPAR
manager system time, change the system equipment time, or synchronize the LPAR
manager system time with an NTP server.
Make sure to save the configuration after enabling NTP. If you
reboot the LPAR manager without saving it, the LPAR RTC
might be out of sync by the time adjusted with NTP.
NOTICE
1235