Hitachi Compute Blade 2000 User Manual page 729

# Item
4 Type
5 Version
6 FRU
7 Sensor
8 ON
9 OFF
10 Connection
11 Turn on
12 Turn off
 Role-dependent variation in available operations
To display detailed information about a switch module, the user must have switch

module permission for that module.
To perform actions on a switch module, the user must have switch module

permission for that module.
Description
The type of the module.
Set such as: 1Gb LANSW, 1_10 LANSW, or 8G FCSW
Firmware version of the module
The FRU information for the module
The value of a sensor installed in the switch module
Turns on power to the module.
Turns off powers to the module.
Connects to the web console of the switch module. Web
console-capable switch modules are as follows:
With the management module firmware version A0182 or
later:
- 1 Gb LAN switch module
- 1/10 Gb LAN switch module
- Internal Fibre-channel switch
With the management module firmware version A0181 or
earlier:
- Internal Fibre-channel switch
When you connect to the web console of a switch module
using the Connection button, configure the switch module
network as shown in the table below. Go to System web
console > Settings > The configuration of network >
Management LAN network general setting > The switch
module to configure the settings to configure the settings.
Item Connected to
1 Gb LAN Internal LAN
switch module network
1/10 Gb LAN Internal LAN
switch module network
Internal Fibre- Management
channel switch LAN network or
an internal port
of the switch
module
If you have configured the settings shown above with the LAN
switch module, check the switch module IP address referring
to Chapter 13 > Network Settings > Setting the IP address.
Turns on the Location ID LED for the module.
Turns off the Location ID LED for the module.
678
IP address
Not required
Not required
Set an IP
address for the
PC to be
connected to
the web
console.