Hitachi Compute Blade 2000 User Manual page 1245

The following table describes each item on this screen.
Official
# Title
Name
(1) # LPAR
Number
(2) Name LPAR Name Displays the LPAR name.
(3) Sta Status
(4) PCI Device# PCI Device
Number
(5) Type Device Type Displays the PCI device type.
(6) Schd Scheduling
Mode
(7) Device Device
Assignment Assignment
(8) PageUp / Page Up /
PageDown Page Down
keys
Description
Displays LPAR numbers.
Displays the LPAR status.
Act (Activate): The LPAR is powered on.
Dea (Deactivate): The LPAR is powered off.
Fai (Failure): The LPAR cannot be used due to an
unrecoverable failure. Reboot LPAR manager when this
happens.
Displays the number that LPAR manager gives each
PCI device for identification purposes.
S: SCSI controller
N: Network interface Card (NIC)
When SR-IOV is enabled, "v" is added to the end.
F: Fibre-channel
U: USB controller
Sets the PCI device's scheduling mode.
D: Assigns to a LPAR in the dedicated mode. (IPF
version LPAR manager only)
E: Assigns to a LPAR in the exclusively shared mode.
S: Assigns to a LPAR in the shared mode.
A PCI device available for changing its scheduling
mode has [+] on the right of Schd. A PCI device, Schd
without [+], is not available for changing its mode.
Sets the assignment of the PCI device to LPARs.
*: unassigned
A: assigned but not activated
R: activated and attached
-: cannot be assigned
LPAR manager firmware version 59-0X/79-0X or later
A USB device with the automatic Attach setting has #
next on the left to the assignment status, A or R.
Page Up: scrolls a page upwards.
Page Down: scrolls a page downwards.
1194
Initial Value
(When LPAR is
added)
-
NO_NAME
Dea
-
-
-
-
(Device type
except USB)
A (Device
type: USB)
-