Hitachi Compute Blade 2000 User Manual page 1213

The following table describes items in the Logical Partition Configuration screen.
# Title Official Name
(1) # LPAR Number
(2) Name LPAR Name
(3) Sta Status
(4) Pro Logical
Processors
(5) Shr Shared
Processors
(6) Ded Dedicated
Processors
(7) Scd Scheduling
Mode
(8) Grp Processor Group LPAR manager firmware 58-3X/78-3X or later
(9) Srv Service Ratio
(10) Mem Memory
(11) VN Virtual Network
Interface Card
Description
Displays LPAR numbers.
Sets the LPAR name.
Displays the LPAR status.
Act (Activated): The LPAR is powered on.
Dea (Deactivated): The LPAR is powered off.
Fai (Failure): The LPAR cannot be used due to an
unrecoverable failure. Reboot LPAR manager when
this happens. Activate, deactivate and reactivate the
LPAR.
LPAR manager firmware 58-2X/78-2X or lower
Displays the number of logical processors allocated
to the LPAR.
LPAR manager firmware 58-3X/78-3X or later Sets
the number of logical processors to allocate to the
LPAR.
LPAR manager firmware 58-2X/78-2X or lower
Sets the number of shared processors allocated to
the LPAR.
LPAR manager firmware 58-2X/78-2X or lower Sets
the number of dedicated processors allocated to the
LPAR.
LPAR manager firmware 58-3X/78-3X or later
Sets a scheduling mode.
S: Shared mode
D: Dedicated mode
Sets a processor group number.
Set a value between 1 and 999 as the relative
allocation of the time (Service ratio) an LPAR uses a
physical processor (Service-time).
This item is only for shared mode LPARs. It is not for
dedicated mode LPARs and cannot be set for them.
Sets the memory size allocated to a LPAR in units of
MB. This is always a multiple of 256.
Displays the number of virtual NICs allocated to the
LPAR.
1162
Initial Value
(When LPAR
is added)
-
NO_NAME
Dea
1
0
1
D
D
100
1024
0