Hitachi Compute Blade 2000 User Manual page 1279

If you keep using LPAR manager without reboot, Menu screen shows a message to
let you know that the reboot is not performed.
+------------------------------------------------------------------------------+
|+-- Menu [LP_192168020] ----------------------------- 2009/02/18 13:29:58 -+ |
||
|| Logical Partition Configuration
|| Logical Processor Configuration
|| Physical Processor Configuration
|| PCI Device Information
|| PCI Device Assignment
|| VNIC Assignment
|| Shared FC Assignment
|| Allocated FC Information
||
|+---------------------------------------------------------------------------+ |
| LP Operating Mode setting was changed. Please Reboot System.
|+-- Tips -------------------------------------------------------------------+ |
|| F3 : Activate F8 : LPAR Screen
|| F4 : Deactivate F9 : Save Configuration
|| F5 : Reactivate
|| F6 : Add Definition Alt + t : Screen Refresh
|| F7 : Remove Alt + r : LP System Shutdown
|+---------------------------------------------------------------------------+ |
| Configure logical partitioning of processors and memory
+------------------------------------------------------------------------------+
| :Move Cursor Enter:Select
+------------------------------------------------------------------------------+
(11) How to set LP CLI IP Address
Standard server blades with LPAR manager firmware version 58-6X or later
/High-performance server blades with LPAR manager firmware version 78-6X or
later
Display the System Configuration screen. Place the cursor on LP CLI IP Address
and press Enter to display a subscreen. On the subscreen, type an LP CLI IP
Address to change and press Enter.
Do not set any multicast address or broadcast address.
The new setting can be applied without F10: Update System
Config. It might take about 10 seconds to update the setting.
(12) How to apply the changes to the LPAR manager system
To apply all the changes made in the System Configuration screen to the LPAR
manager system, press F10: Update System Config and select Yes in the
confirmation subscreen that opens.
After selecting "Yes", you will not be able to perform any operations on LPAR
manager for one to three minutes.
To cancel the changes, press F10: Update System Config and select No in the
confirmation screen that opens. All changed settings will be restored to their original
values.
You cannot move to other screens while changes are being made. To move to
another screen, press F10, select either Yes or No, and conclude the change
process.
Because it takes time for the changed settings to be reflected in the LPAR manager
system, the movement to another screen is not allowed before the reflection has
finished completely. If you go to another screen, press F10: Update System
Config and select Yes to complete the reflection, or select No to cancel the
changes.
System Configuration
System Service State
Date and Time
LP Options
LPAR Usage
Front Panel
LP System Logs
Firmware Version Information
LP Ver. : VV-RR(TT-KK)
1228
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
|
| |
| |
| |
| |
| |
|
|