Hitachi Compute Blade 2000 User Manual page 1274

between LPARs is lost for several minutes.
SC/BSM shows that LPAR manager is deactivated and no error notification is
performed.
(1) How to set the LP ID
Display the System Configuration screen.
Place the cursor on the LP ID and press Enter to display a subscreen. Enter the
new ID on the subscreen. You can use up to 16 characters for the ID.
You can enter the following characters.
Alphanumeric, "~", "@", "#", "$", "%", "^", "-" (hyphen), "+", "=", "_" (underscore),
"." (period), "[", "]"
LP ID is used to identify of each when the multiple LPAR manager systems exist.
For example, when you control the LPAR manager system from
ServerConductor/Blade Server Manager (BSM), LP ID is used to identify each.
Therefore, when setting the LP ID, set a value that is unique among all systems
including Compute Blade 1000, 2000, and 320.
LPAR manager does not check if the entered value is used for another LPAR
manager system.
You can change the LP ID only when all LPARs are deactivated.
(2) How to set the LP IP Address
Display the System Configuration screen.
Place the cursor on the LP IP Address and press Enter to display a subscreen.
Enter the new address on the subscreen and press Enter.
The LP IP Address is set as 0.0.0.0 by default. Without setting another address
except 0.0.0.0 at the first boot, however, the LPAR manager system will not boot.
Do not set a multicast address and broad cast address.
(3) How to set the Subnet Mask
Display the System Configuration screen. Place the cursor on the Subnet Mask
and press Enter to display a subscreen. Enter the new Subnet Mask on the
subscreen and press Enter.
(4) How to set the Default Gateway
Display the System Configuration screen. Place the cursor on the Default
Gateway and press Enter to open a subscreen. Enter the new Default Gateway on
the subscreen and press Enter.
(5) How to set the ServerConductor/Blade Server Manager (BSM) IP Address
Display the System Configuration screen. Place the cursor on the BSM IP
Address and press Enter to display a subscreen. Enter the new System Manager
IP Address on the subscreen and press Enter.
With Standard server blades with LPAR manager firmware
58-4X or later versions/ High-performance with LPAR
manager firmware 78-4X or later versions, operation with F10:
Update system Config is not required for update. It might take
about ten seconds for update.
1223