Hitachi Compute Blade 2000 User Manual page 1409

The following table lists the errors contained in messages output by the command and the
corresponding termination codes.
Error message and
termination code
Invalid Option. An invalid option is specified.
0x01010000
Target Host The specified host is not found.
Unreachable.
0x01020000
Response Timeout. The specified host has not
responded.
0x01020001
Unknown Data Unexpected data has been
Received. received.
0x01030000,
0x000000ce,
0x000000cc
failed to bind. Network bind operation has failed.
0x01030001
failed to activate Failed to establish a
session. communication session.
0x01030002
Cannot Write File Failed to write data to a file.
or Given Too
Long File Name.
0x01040000
Target LPAR is The specified LPAR is not defined.
undefined.
0x04000000
Unexpected An internal error has occurred.
Exception was
raised.
0xffffffff
Invalid Command The target host failed to accept the
Received. HvmGetPerf command.
0x000000c1
Description
Check the command options.
Check that the specified address is
correct and that the specified
target host is operating normally.
Check that the specified address is
correct and that the specified
target host is operating normally.
Check that the specified target
host is operating normally.
Check the communication
configuration. Alternatively, wait
for a while and retry.
Check the number of SC/BSM
devices concurrently connecting to
the LPAR manager and whether
other machines are executing the
HvmGetPerf command
simultaneously.
Check that the specified file is
write-enabled.
Alternatively, shorten the length of
the filename.
When using the lpar option,
specify only a defined LPAR.
Check the command options,
network conditions, and the
operating status of the specified
LPAR manager.
Check whether the LP IP address
is specified.
1358
Action