Hitachi Compute Blade 2000 User Manual page 609

If you enter M in the VLAN setting menu and press Enter, the current VLAN setting
appears, and a prompt for the target port to be selected appears. If you connect the
target port to a partition or switch module, specify the partition number and switch
module slot number. When the target port for transfer is selected, the prompt appears
for a VLAN ID. Enter the VLAN ID, and the changed setting value is displayed. A
confirmation message appears. At the prompt, enter Y and press Enter, and the VLAN
setting is saved. To cancel the setting change, enter N and press Enter, or just press
Enter.
(M,C,D,[Q]) : M (Enter)
-- VLAN setting --
Partition
VLAN ID Ext port M 0 1 2 3 4 5 6 7 0 1 2 3 4 5
------- -------- - --------------- -----------
Untag0 MGMT-0 X X X X X X X X X X X X X X X
Untag1 MGMT-1 - - - - - - - - - - - - - - -
Select target (0=Management module,1=Partition,2=Switch
module,[Q=Quit]) : 0
(Enter)
VLAN ID (Z=Untag0,G=Untag1,2-4000,[Unchange]) : G (Enter)
-- VLAN setting --
VLAN ID Ext port M 0 1 2 3 4 5 6 7 0 1 2 3 4 5
------- -------- - --------------- -----------
Untag0 MGMT-0 X X X X X X X X X X X X X X X
Untag1 MGMT-1 - - - - - - - - - - - - - - -
Confirm? (Y,[N]) : Y (Enter)
- Writing setting was completed.
Hit enter key. (Enter)
Switch module
Partition Switch module
558