Hitachi Compute Blade 2000 User Manual page 771

# Item
When Network OS version 3.0.0 is on a Brocade 10 Gb
DCB switch module, the default gateway setting from the
management module does not take effect on the switch
module. Log in to the switch module and configure it using
the ip route command. See the Network OS Administrator's
Guide for details. If Network OS version 2.0.1 is on the
switch module, you cannot configure the gateway.
The VLAN configured by users
# Item
1 VLAN ID
2 External
connection port
3 MM, P0 to P7,
SW0 to SW5
Internal LAN network
# Item
1 Network address
2 Subnet mask
Do not change the internal network address while the
server blade works. If you do, failure error events, which
have occurred while the management module is restarting,
may not be detected.
When changing the address while the server blade with
N+M cold standby enabled is not in operation, make sure
to perform Smart Configure afterwards.
MAC address
# Item
1 Module
2 Controller 0
Description
is executed, the management module setting will be
applied to the switch module.
No: Synchronization cannot be executed.
Description
The LAN ID.
Set as: 2 to 4000
You can delete a VLAN by deleting its VLAN ID.
The external connection port used by the VLAN.
You can select Management LAN port 0 or Management
LAN port 1.
Indicates which user-defined VLAN is associated with
each module and physical partition.
Description
The network address of the internal LAN network:
Changing internal LAN network addresses makes the
management module restart.
Do not set the internal network address to 192.168.0.0 or
192.168.254.0.
The subnet mask of the internal LAN network.
Fixed at 255.255.255.0.
Description
The module number.
The MAC address of controller 0.
720
Edit
Edit
Yes
Yes
Yes
Edit
Yes
Edit