Configuration Command Mode - Hitachi Compute Blade 2000 User Manual

Configuration command mode

If you enter the configure command in the system administrator mode, this mode will
be set.
You can configure or reconfigure the system by using the configuration command in
this mode.
The configuration command mode provides a

hierarchical structure. The configuration command
(config)# in the table above (config)# is called the global
configuration mode, and supports input modes classified
depending on a command type. For details about
configuration command mode, see the Configuration
Guide"
Information on the user levels in which you can run the

operation command is described in the Operation
Command Reference in the Software Manual.
Information on input modes in which you can run the
configuration command is described in the Configuration
Command Reference.
806