Hitachi Compute Blade 2000 User Manual page 1496

Message content
Explanation LPAR manager shutdown was canceled due to LPAR migration in
execution.
LPAR manager Aborts the specified process.
operation
What to do Wait a while until LPAR migration is complete and then retry the
specified process.
LPAR manager is not executable condition for this request.
Message content
Explanation The LPAR manager system is not in the condition to execute the
requested processing.
LPAR manager Aborts the specified process.
operation
What to do Wait a moment and then retry the specified process.
Message content
Explanation LPAR manager configuration information could not be saved.
LPAR manager Aborts the specified process.
operation
What to do Perform Force Recovery in the System Service State screen.
LPAR manager is recovering specified LPAR from
Message content
This operation prevents some operations from performing.
Explanation Does not allow you to operate screens because the failed LPAR in
LPAR migration is currently being recovered.
LPAR manager The failed LPAR in LPAR migration is being recovered.
operation
What to do None.
Message content
Explanation LPAR manager configuration information could not be saved.
LPAR manager Aborts the specified process.
operation
What to do Wait a while and try again.
Message content
Explanation When you tried to set the number of dedicated logical processors, a
sufficient number of physical processors could not be secured.
When an LPAR is activated, the physical processors assigned to the
LPAR cannot be secured.
LPAR manager Aborts LPAR activation.
operation
What to do Reduce the number of processors allocated or try again to activate the
LPAR after you have deactivated a currently active LPAR.
Alternatively, check the Logical Processor Configuration screen.
LPAR manager is executing LPAR Migration.
LP System Shutdown was canceled.
Please wait.
LPAR manager is not ready for the operation
failed-migration state.
Inhibit ICV request for the operation
Insufficient Processor resource
1445