Hitachi Compute Blade 2000 User Manual page 1283

The following table describes each item on this screen.
Official
# Title
Name
(1) SVP Access SVP access
(2) BSM Access BSM access
(3) HA Monitor HA monitor
(4) NTP NTP
(5) Force Forced
Recovery recovery
(6) BMC BMC
Description
Displays the SerVice Processor (SVP) access status.
RUN: The service is operating normally.
STOP: The service is stopping.
ERROR: The service is in the error state.
UNKNOWN: No updates from the service patrol.
Displays the ServerConductor/Blade Server Manager
(BSM) access status.
RUN: The service is operating normally.
STOP: The service is stopping.
ERROR: The service is in the error state.
UNKNOWN: No updates from the service patrol.
Displays the HA Monitor status.
RUN: The service is operating normally.
STOP: The service is stopping.
ERROR: The service is in the error state.
UNKNOWN: No updates from the service patrol.
LPAR manager firmware version 58-7X/78-7X or later
Displays NTP status.
SYNC: Synchronization with NTP is successful.
NO SYNC: Synchronization with NTP is not executed.
ERROR: Synchronization with NTP failed.
INACTIVE: Synchronization with NTP is cancelled.
With multiple NTP servers configured, having
synchronized with any NTP server shows SYNC; not
with any NTP server shows ERROR.
Recovers the System Service when it is not operating
normally.
Note: Operation with Force Recovery should be done
with no activated LPAR. If it is operated with an activated
LPAR, network communication between LPARs is lost
for several minutes. SC/BSM shows that LPAR manager
is deactivated and no error notification is performed.
Displays the physical Baseboard Management
Controller (BMC) status.
RUN: BMC is operating normally.
ERROR: BMC is in the error state.
1232
Initial
Value
STOP
STOP
STOP
No
SYNC
-
RUN