Hitachi Compute Blade 2000 User Manual page 1517

Message content LPAR Manager detected the success of retrying the setting of
Level Information
Explanation Retry of the operation to configure TxRate finished .
What to do None.
Message content LPAR manager detected the duplication of I/O slot expansion
Level Warning
Explanation Duplication of an I/O slot expansion unit number was detected.
What to do Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message content LPAR manager detected the success of retrying the setting of
Level Information
Explanation Retrying the setting of TxRate was successfully.
What to do None.
Message content LPAR manager detected too many physical CPUs, some CPUs
Level Warning
Explanation Ignored some CPUs due to those CPUs installed beyond the
maximum number of them that LPAR manager can recognize.
What to do Contact your reseller or maintenance personnel.
Message content LPAR manager detected uninitialized Shared device.
Level Error
Explanation Detected an uninitialized shared I/O device.
What to do Contact your reseller or maintenance personnel.
Message content LPAR manager detected unsupported version of firmware on a
Level Error
Explanation Detected not-supported NIC firmware version.
What to do Check if your NIC firmware version is supported by LPAR manager.
When you cannot solve the problem, contact your reseller or
maintenance personnel.
Message content LPAR Manager failed to get the firmware version on a NIC
Level Error
Explanation An attempt to obtain the firmware version from the NIC device failed.
What to do Restart LPAR Manager. If this LPAR Manager system log is
collected even after you restart LPAR Manager, contact your
reseller or maintenance personnel.
TxRate configuration.
unit number.
TxRate configuration.
are ignored.
NIC device.
device.
1466