Serial Interface Connection - Hitachi Compute Blade 2000 User Manual

Serial interface connection

Select a LAN switch module to connect using the SCO command. Connect your setup
terminal to the serial port on the management module installed in the system
equipment using the RS-232C cross cable.
When two management modules are installed, connect to the management module
with the Master (MSR) light emitting diode (LED) that lights solid green.
Prepare the RS-232C cross cable for connection.
Setup terminal requirements
Communication port
Communication software
Communication
setting
*1 In the shipment settings of this system, the communication speed of the console port is set
in 9600 bits/s. To use another rate, see the Speed command for operation terminal
connection, "Configuration Command Reference Vol.1" in the CD-ROM attached to this
device.
Item
RS-232C port
Any of the following communications software
products or its equivalent communication software
- Hyper terminal attached to Windows 2000 or
Windows XP
- Tera Term Pro (Version 2.3)
Communication ZMODEM protocol
protocol
Communication 8 bits, 1 stop bit, no parity
parameter
Communication 19200bit/s, 9600bit/s, 4800bit/s, 2400bit/s, 1200bit/s
rate *1
804
RS-232C
cross cable
Setup terminal
MSR
Specification