Hitachi Compute Blade 2000 User Manual page 1524

Message content
Warning Warning
Explanation LPAR manager logical firmware detected an internal error and the
error is recovered.
What to do If this LP system log is often collected, contact your reseller or
maintenance personnel.
Message content
Level Error
Explanation LPAR manager logical firmware detected an internal error.
What to do Contact your reseller or maintenance personnel.
Message content LP-LFW detected not enough memory to activate
Level Warning
Explanation LPAR manager logical firmware detected that memory is not enough
to activate the LPAR.
What to do Assign more number of memories, and then activate the LPAR.
Message content
Level Information
Explanation LPAR manager logical firmware detected a network failure while the
network is booting, and the failure was recovered.
What to do None.
Message content
Level Warning
Explanation LPAR manager logical firmware detected a network failure while the
network is booting.
What to do Check loading on the network and correct it if needed, and reboot
the network. If this LP system log is collected regardless of your
rebooting the network, contact your reseller or consult your
maintenance personnel.
Message content
Level Information
Explanation I/O interrupt vector mode was changed.
What to do None.
Message content
Level Information
Explanation LPAR manager corrected the invalid status of the ptc.l instruction.
What to do None.
LP-LFW detected internal error.
LP-LFW detected internal error.
LPAR.(LPAR:X)
LP-LFW detected tftp error and recovered.
LP-LFW detected tftp error.
I/O interrupt vector mode was changed.
Invalid State was recovered. (ptc.l)
1473