Hitachi Compute Blade 2000 User Manual page 587

Item Description of item
Inter-blade SMP
0-7
connection board
Server
Partition to belong
blade X
Editing status per
partition
Select a menu item from the following list to perform the function.
Menu
C. Configure partition
W. Write configuration
Q. Quit
If you enter C in the PR command menu and press Enter, you can change the
partition configuration. You are required to select a partition at the prompt. Enter a
partition number, and the number of server blade slots that can belong to the partition.
Input the setting value and press Enter to go on the next setting. To delete the partition,
enter D.
Repeat the procedure to achieve your planned partition configuration. Then enter W in
the menu and press Enter to apply the configuration. A confirmation message appears.
Enter Y and press Enter, and the partition setting becomes effective. To cancel the
setting, enter N and press Enter or just press Enter after the confirmation message
appears.
Partition configuration can be applied only when the selected partition is powered off.
Value
S Installed in the server blade.
= Blades sandwich this symbol
install this board.
X Belongs to.
- Does not belong to.
(Created) Initializes the setting to create it.
(Modified) Takes over the setting to change
it.
(Deleted) Deletes the partition
None Nothing is edited.
Description
Edits the partition configuration.
Applies the partition configuration.
Returns to the previous menu.
536
Description of value