Hitachi Compute Blade 2000 User Manual page 922

Prepare the following items for connection via the LAN port:
A terminal for the system console

Unshielded twisted pair (UTP) cable: UTP-5 or above

Client software: Telnet or Secure SHell (SSH)

When you connect an I/O module via Telnet or SSH, refer to
the following table about the default setting of the I/O module
at the time of shipment:
Item
IP address
Subnet mask
SSH
Telnet
Prepare the following items for connection via the serial

port.
A terminal for the system console

A connecting cable for the serial port (RS-232C

cross cable D-SUB9 pin female-female connector)
Terminal software such as Hyper Terminal: available

for VT100 emulation
When you connect to the serial port of an I/O module, refer to
the following table about communication parameter settings
to the terminal software.
Communication parameter
Communication rate
Data
Parity
Stopbit
Flow control
Setting at the shipment
192.168.0.65
255.255.255.0
Enabled
Enabled
Setting
9600 bps
8 bits
None
1 bit
None
871