Hitachi Compute Blade 2000 User Manual page 792

The settings of Compute Blade side
# Item
1
Port number
The setting of SC/BSM side
# Item
1 Server name
2 IP address
3 Port number
4 Alert level
5 Alert retry interval
(sec)
6 Alert retry duration
(min)
When configuring a management server, check Deletion
of the settings for unused management servers.
Sending an alert information
# Item
1
Submit
 Role-dependent variation in available operations
To display and edit information in the SC/BSM linkage letup view, the user must
have chassis permission.
Do not perform an N+M cold standby switching test by
issuing an alert in this screen together with LPAR migration
targeted to that partition. Refer to Chapter 12: Logical
partitioning manager in this User's Guide for the further
information.
Description
The port number used to connect to SC/BSM.
Set as: 0 to 65535
If "0" is set, the port to connect SC/BSM is closed
Description
The management server name.
A management server name can contain a maximum of
15 alphanumeric characters or symbols.
The IP address of the management server.
The port number used to send alerts.
Set as: 1 to 65535
The alert notification level.
You can select disable, alert, information, or all.
The interval between attempts by SC/BSM to send an
alert notification (in seconds).
Set as: 5 to 50
The length of time SC/BSM continues to retry sending the
alert notification (in minutes).
Set as: 4 to 20
Description
Sends an alert. You can send one of two alert types,
N+M cold standby (immediate switchover) and N+M cold
standby (delayed switchover).
To send an alert, select the destination partition and the
alert type, and then click Send.
741
Edit
Edit
Yes
Yes
Yes
Yes
Yes
Yes
Edit
Yes