Hitachi Compute Blade 2000 User Manual page 1332

The following table describes each item on this screen.
# Title Official Name
(1) # LPAR number Displays LPAR numbers.
(2) Name LPAR name
(3) Sta Status
(4) Liquid Liquid crystal
Crystal
Display
(5) Dump Dump
(6) CLD Console Log
Display
(7) CLE Console Log
Erase
(8) PageUp / Page Up /
PageDown Page Down
key
(9) Comment Comments
(10) Error event Error event
detected detection
# Title
Activated
(1) #
(2) Name
(3) Sta
(4) Liquid Crystal
Display
(5) Dump
(6) CLD
(7) CLE
(8) PageUp /
PageDown
(9) Comment
: can be executed. -: cannot be executed.
Description
Displays the LPAR name.
Displays the LPAR power status.
Act (Activate): The LPAR is powered on.
Dea (Deactivate):The LPAR is powered off.
Fai (Failure): The LPAR cannot be used due to an
unrecoverable failure. Reboot the system when this
happens.
Displays the LPAR's system status and error
information.
Active: The power is on.
System power-off: The power is off.
Ignite dump: A state when a dump is collected
MigrationFailed: LPAR migration fails, which
requires LPAR recovery.
Commands a guest OS to collect dump.
This can be used only when the LPAR is activated.
Displays the selected LPAR's guest screen data
(console log data).
Deletes the selected LPAR's guest screen data
(console log data) from the buffer in LPAR manager.
Page Up: scrolls the Front Panel frame upwards.
Page Down: scrolls the Front Panel frame
downwards.
Displays a brief description of the selected item.
Displays that LP system logs at the error level are
detected.
When this is displayed, check the LP system log in
the LP System Logs screen.
See LP system logs for checking LP system logs.
To delete this display, press the Esc key with this
screen or open the system logs screen.
Guest status
Deactivated Failure
-
- -
-
- -
-
- -
-
- -
-
 -
  
  
-
- -
-
- -
1281
Initial Value
-
NO_NAME
Dea
-
Void / Dump
Dsp
Ers
-
-
-
Remarks
Display only
Display only
Display only
Display only
Display only
Display only