Hitachi Compute Blade 2000 User Manual page 535

Information on the on Default Physical WWN is described in the table below.
Description of
Item
item
P Partition number
Server blade
S
number
FC card type and
Card
slot number
Port Port number
World
wide port WWPN
name
World
wide node WWNN
name
When connected to an I/O slot expansion unit, the unit's part/model number and serial
number, and information on the I/O adapter of the I/O slot expansion unit included in
the partition.
When a Fibre-channel adapter has two ports, information

on four ports is displayed. In this case, the Fibre-channel
adapter WWNs are displayed in port0 and port1, and "0"
is displayed in port2 and port3 as WWN values.
For 10 Gb converged network adapter (CNA) adapter or

10 Gb CNA board, the following values are shown.
WWN for port 0 is the WWN value for port 0 of the controller 0.

WWN for port 1 is the WWN value for port 1 of the controller 0.

WWN for port 2 is the WWN value for port 0 of the controller 1.

WWN for port 3 is the WWN value for port 1 of the controller 1.

WWN is shown only when CNA Personality setting is
Fibre Channel over Ethernet (FCoE).
When a single CNA controller is installed, WWN values
for port 2 and port 3 are shown as all 0, zero.
For Emulex 8 Gb 2-port fibre channel mezzanine card,

current WWN may be shown in the Default Physical
WWN field.
Applicable extensible firmware interface (EFI) firmware versions with each

server blade model are as follows:
- All EFI firmware versions with standard server blade X55A1 and X55A2
models
- All EFI firmware versions with high-performance server blade X57A1 model
- EFI version 07-29/08-29 or earlier with high-performance server blade
X57A2 model
To find the Default Physical WWN for Emulex 8 GB 2-port fibre channel

mezzanine card, perform the following steps:
1. Shut down the OS and power off the server blade.
2. Power on the server blade and boot the OS.
3. Check the Default Physical WWN without rebooting the OS.
Value
0 to 7
0 to 7
ECX
IOXX
0 to 3
-------
XX:XX:XX:XX:XX:XX:XX:XX
+XX:XX:XX:XX:XX:XX:XX:XX
-------
XX:XX:XX:XX:XX:XX:XX:XX
+XX:XX:XX:XX:XX:XX:XX:XX
484
Description of value
-
-
Expansion card
I/O adapter
-
No card installed.
Default Physical WWN
User Default Physical WWN
No card installed.
Default Physical WWN
User on Default Physical
WWN