Lpar Manager Boot Messages - Hitachi Compute Blade 2000 User Manual

LPAR manager boot messages

Message content
Explanation LPAR manager configuration file cannot be restored from the
management module due to the invalid LPAR manager configuration
file in the management module. Restore the correct LPAR manager
configuration file.
What to do Restore the correct LPAR manager configuration file.
Message content
Explanation LPAR manager cannot boot due to the Enabled SMT setting.
What to do Set Disable in SMT using the server blade Web console.
Message content
Explanation LPAR manager cannot boot due to the Enabled hardware memory
dump setting.
What to do Set Disabled in the EFI setup menu: [Advanced] > [hardware memory
dump Settings] > [hardware memory dump].
LPAR manager Loader detected flash memory access error and
Message content
Explanation Automatic recovery was performed due to failure in the flash memory.
Since the copy to the flash memory failed, however, configuration was
loaded from the management module.
What to do If this LP system log is collected at every LPAR manager boot, contact
your reseller or consult maintenance personnel.
Message content
Explanation LPAR manager cannot boot due to the file with incorrect configuration.
What to do Restore a file with a correct configuration.
LPAR manager loader detected the damage of flash memory and
Message content
Explanation LPAR manager detected flash memory failure and recovered
automatically.
What to do None.
Invalid LPAR manager configuration files exist in the SVP.
Please restore valid LPAR manager configuration files.
Invalid SMT setting. (SMT is enabled. (01))
Please Power Off Partition.
LPAR manager Loader detected enable H/W Memory Dump
setting in this system. [INFO:XX]
Please set H/W Memory Dump setting to disable.
load configuration from SVP.
LPAR manager Loader detected invalid configuration
files.[version is unmatch] (ErrorCode:XXXXXXXXXXXXXXXX
AdditionalCode:XXXXXXXXXXXXXXXX)
Please Power Off Partition.
recovered.
1440