Hitachi Compute Blade 2000 User Manual page 1291

# Title Official Name
(15) TimeSync Time
Synchronization
(16) NTP Server 1 NTP server
– 2 setting
(17) PageUp / Page Up /
PageDown Page Down
keys
(18) Function Key Function key
(19) Error Event Error event
Detected detection
Function
LPAR manager firmware version 58-7X/78-7X or
later
Selects one of NTP time synchronization settings.
Disable: Not synchronize the time with an NTP
server.
NTP: Synchronizes the time with the NTP server
specified to NTP server 1 or NTP server 2.
SVP: Synchronizes the time with the NTP server
on SVP.
LPAR manager system time synchronization with
the NTP server is performed immediately after
LPAR manager bootup and then every 15
minutes.
LPAR manager firmware version 58-7X/78-7X or
later
Configures an IP address for NPT servers.
- This item is effective only when TimeSynch is
set to NTP.
- Configure an NTP server with NTP version 3 or
4.
Page Up: scrolls the SEL Date and Time frame
upwards.
Page Down: scrolls the SEL Date and Time frame
downwards.
Displays function keys available on this screen.
F6: Changes the LPAR manager display time.
F7: Changes the LPAR manager system time
zone.
Those keys are available only when TimeSync is
set to Disable.
Displays that LP system logs at the error level are
detected.
When this is displayed, check the LP system log
in the LP System Logs screen.
See LP system logs for checking LP system logs.
To delete this display, press the Esc key with this
screen or open the system logs screen.
1240
Initial Value
(When LPAR is
added)
Disable
None
-