Hitachi Compute Blade 2000 User Manual page 1316

Save Changed Config Format
#
Disable
format was updated, saving the
Configuration is necessary.
Please press the F9 key."
(3) Sends an alert to save configuration when the F9 key is pressed. 59-0X/79-0X or
(b) Saving configuration automatically at LPAR manager halt
The following table describes behaviors depending on the setting when
configuration has not been saved at LPAR manager halt.
Save Changed Config Format
#
Disable
(1) The following menu item is
shown in the "Alt + r menu:
Config save and Shutdown
(2) Selecting "Config save and
Shutdown" saves the
information and then performs
shutdown.
Selecting "Shutdown" performs
shutdown without saving
configuration.
Place the cursor on Save Changed Config Format and press Enter to show a
subscreen. On the subscreen, select Enable or Disable and press Enter.
(9) How to skip the confirmation prompt subscreen when activating a LPAR
Display the LP Options screen.
Place the cursor on Activation below Confirmation, and press Enter to display a
subscreen. Place the cursor on No, and press Enter. To display the confirmation
prompt subscreen, select Yes.
You can also stop displaying the confirmation prompt subscreen by activating the
LPAR, selecting Continue: Don't show this message on the confirmation prompt
subscreen and pressing Enter.
+-----------------------------------+
| LPAR1[LPAR1]
| Activation means power-on.
| Do you continue?
|
| Continue
| Cancel
| Continue(Don't show this message) |
+-----------------------------------+
Enable
Enable
Selecting "Shutdown"
automatically saves the
information and then performs
shutdown.
-
|
|
|
|
|
|
---
1265
Version
supported
later
Version
supported
Not supported
Not supported