Move Between Guest And Lpar Manager Screens - Hitachi Compute Blade 2000 User Manual

Move between guest and LPAR manager
screens
 Moving from a guest screen to an LPAR manager screen
1 Press and hold the Ctrl key, and press the switching character.
The default switching character is "l" (lower case "L").
* You can change the switching character by changing the Screen Switching
Character in Options. However, you cannot use b, h, i, j, m, q, s, and z, since
these characters are reserved for the SVP console.
+------------------------------------------------------------------------------+
|+- Options ------------------------------------------------------------------+|
|+- System Control ---------------------+- LP Dump Operation ----------------+|
|| Pre-State Auto Activation
|| LP Auto Shutdown
|| Shutdown State
|| LP ErrorWatching
|+--------------------------------------+
|+- Confirmation -----------------------+
|| Activation
|| Deactivation and React+----------------------------+
|+-----------------------| Screen Switching Character |
|+- Screen Switching Char|
|| LPAR --> LP
|+-----------------------+----------------------------+
|+- NVRAM Operation --------------------+
|| Clear NVRAM
|| Copy NVRAM From
|+--------------------------------------+
||
|+----------------------------------------------------------------------------+|
|
+------------------------------------------------------------------------------+
|
+------------------------------------------------------------------------------+
* If the LPAR has the virtual COM console enabled from which connected to the
LPAR guest screen, you can operate the LPAR manager screen without this
procedure.
See Virtual COM console function
No | Take LP Dump
No +-------------------------------------+|
Ready |
Yes |
Yes |
| l
LPAR4 |
LPAR1 To LPAR4 |
for how to use the virtual COM console.
1150
Execute ||
||
||
||
||
||
||
||
| ||
| ||
||
||
||
||
||
||
|
Esc:Menu |