Hitachi Compute Blade 2000 User Manual page 1477

LPAR manager
LPAR
setting change
(Target
LPAR)

Memory size (Mem)
change

Memory node
number (MN)
change

AutoAct (AA) setting
change
AutoClear (AC)

setting change
Service rate (Srv)

change
Idle detection (ID)

change
ProcessorCapping

(PC) setting change
Virtual COM console
-
(VC) setting change
Change in device assignment to LPAR and setting
USB device -
assignment
NC/FC scheduling

mode change
VNIC Device Type -
setting
NIC assignment/ 
unassignment

MAC address
change of NIC
FC assignment/ 
unassignment
FC vfcID change 
VLAN setting to NIC -
Promiscuous -
setting to NIC
Inter-LPAR packet -
filtering setting to
NIC
Addition and deletion of LPAR
LPAR 
addition/deletion
LPAR activation 
LPAR deactivation

LPAR manager firmware update
LPAR manager 
firmware update
System transfer
Transfer from LP

mode to Basic mode
Affected area
LPAR LPAR LPAR
(Other manager manager
LPAR) (Service) (System)
- - -
- - -
- - -
- - -
- -

- - -
- - -
- - -
- - -
-
 
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
  
  
1426
Remarks
Performance of the
LPARs using a shared
CPU changes between
before and after the
setting change.
Performance of the target
LPARs changes between
before and after the
setting change.
Deactivating the target
LPARs is not required.
Assign a device to the
LPAR deactivated, and
attach the device to the
LPAR activated.
Deactivate all LPARs..
Deactivating the target
LPARs is required.
.
Deactivating the target
LPARs is not required.
To set VLAN to VF NIC,
deactivating target LPARs
is required.
Deactivate an LPAR to
delete.
Make sure to reboot the
server blade before
execution with the
updated firmware.
Make sure to reboot the
server blade.