Hitachi Compute Blade 2000 User Manual page 1206

# Key
16 F10 Used to change the schedule mode for the PCI device.
Used to reflect specific settings, such as logical partitioning
manager (LP) identifier (ID) and VNIC System Number, in the
LPAR manager system.
17 F11 Scrolls the displayed page to the left.
18 F12 Scrolls the displayed page to the right.
19 Alt + t Refreshes the LPAR manager screen.
・ Resets the cursor position in the following screens:
- Logical Partition Configuration,
- Logical Processor Configuration,
- PCI Device Assignment,
- VNIC Assignment,
- Shared FC Assignment
- Date and Time,
- Front Panel
(Note) When the cursor position is reset, it is repositioned
over the item with the lowest LPAR number defined in the
above screens and at the far left within the selectable row.
However, the cursor position is not set again even if Alt+t is
executed while the subscreen is displayed during the LPAR
setting or the like.
・ Forcibly displays the cursor.
(Note) If there are no selectable items on the subscreen that
is displayed by F3 ~ F8, the cursor will be hidden (positioned in
the bottom left corner of the screen). This key operation
forcibly displays the cursor. This might lead to a confusing
screen display with the main screen and the subscreen
overlapping.
20 Alt+r Shutdown the LPAR manager system.
After the shutdown process completed, the power of the server
blade will turn off.
21 Ctrl+b Returns to the system console of the management module.
Operation/Role
1155
Screen on which
operation is
performed
PCI Device
Assignment
System
Configuration
Any screen that can
move to the left or
right
Any screen that can
move to the left or
right
All screens
All screens
All screens