Connection To Setup Terminal - Hitachi Compute Blade 2000 User Manual

Connection to setup terminal

A setup terminal connected via a local area network (LAN) or serial cable is initially required.
This section describes how to connect a terminal to the module in each method.
LAN interface connection
You can access the built-in Fibre-channel switch through the LAN port of the
management module or the LAN port of the built-in Fibre-channel switch for managing
the built-in Fibre-channel switch. You can determine which LAN port to use and set it
by using the LAN configuration (LC) command, a system console command of the
management module.
Network connection specifications (default value set during shipment)
Item
IP address
Subnet mask
Connection type
Via LAN port of the management module

When the connection setting is dedicated to the management module, you can
access the switch module via the management module. You can also access
directly to the switch module through a management module port, MGMT0 or
MGMT1. These settings can be changed using the management module system
console command or Web console.
Setting value
switch module2: 192.168.253.37
switch module3: 192.168.253.38
switch module4: 192.168.253.39
switch module5: 192.168.253.40
255.255.255.240
Dedicated to the management module
MGMT0
859
LAN cable
System console terminal