Hitachi Compute Blade 2000 User Manual page 688

If you enter M in the SC command menu and press Enter, the current settings for
security strength of management modules are displayed. At the prompt, enter a
security strength level. The new setting value is displayed. A warning message
showing the management module restart appears. A confirmation message displays,
prompting you to confirm the new setting. To add the setting, enter Y and then press
Enter. The management module will restart to disconnect the active console. To
cancel the operation, enter N and then press Enter, or just press Enter.
-- Security strength of management module --
Security strength : High
Security strength (0=Default,1=High,[Q=Quit]) : 0
-- Security strength of management module --
Security strength : Default
WARNING : If confirm, management module restart and this connect is lost.
Confirm? (Y,[N]) : Y
If a partition is powerd on or has not been initializated, you
cannot set the security strength. For a server blade with N+M
cold standby enabled, make sure to execute Smart configure
after the management module has restarted.
If you enter P at the SC command menu and press Enter, the current settings for
security strength of all partitions are displayed. At the prompt, enter a partition number
and security strength level. The new setting values are displayed. A warning message
showing BMC restart displays if the partition setting is changed. A confirmation
message displays, prompting you to confirm the new setting. To add the setting, enter
Y and then press Enter. To cancel the operation, enter N and then press Enter, or
simply press Enter.
-- Security strength of partition --
P Security strength
- -----------------
0 High
1 High
2 High
3 High
4 High
5 High
6 High
7 High
Select partition (0-7,A=All,[Q=Quit]) : 0
Security strength (0=Default,1=High,[Q=Quit]) : 0
637