Hitachi Compute Blade 2000 User Manual page 847

ID Level
FF09 Information The synchronization of time is resumed. (Location:X)
Description: Time synchronization by NTP server has resumed in Location X.
Action: Check the time clock in the specified module, and correct the time if necessary.
FF0B Error A report to a support center failed. (Report:ｘ)
Description: A failure occurred at the communication function shown as x, and the support
center is disconnected.
Action: Contact maintenance personnel.
FF0F Information A report is resumed. (Report:X)
Description: A report shown as X is resumed.
Action: None.
FF10 Information Power saving event occurred. (Location:X,Event:Y)
Description: A power saving event shown as Y, which occurred in location X, is logged.
Action: None.
FF11 Warning Power saving <warning> event occurred. (Location:X,Event:Y)
Description: A warning event for power saving shown as Y, which occurred in location X, is
logged.
Action: Check and correct settings for power saving if necessary. If the message is still
shown without problems in the power saving settings, contact your reseller or maintenance
personnel,
FF18 Information On <X>, maintenance mode is started.
Description: Maintenance work has started in Location X. This message may be displayed
several times.
Action: Since Location X is in maintenance mode, do not operate the module in Location X.
FF19 Information On <X>, maintenance mode is ended.
Description: Maintenance work has been completed in Location X. This message may be
displayed several times.
Action: None.
FF22 Error On <X>, a failure occurred in <Y> during smart configure.
Description: When a smart configure process is performed in the server blade shown in
Location X, an error occurred in Location Y.
Action: Contact your reseller or maintenance personnel.
On <X>, an invalid setting was found in <Y> during pre-boot
FF23 Warning
configuration.
Description: A smart configure process in the server blade shown in Location X failed due to
incorrect settings in Location Y.
Action: An HBA slot number and port number are shown in Y. Find and correct HBA BIOS
settings in the specified slot. Then perform Smart Configure manually. If the same message
is displayed after the correction, contact your reseller or maintenance personnel.
FF24 Error On <X>, a smart configure error was detected.
Description: An error was detected in Smart Configure on the server blade in Location X.
Action: Contact your reseller or maintenance personnel.
On <X>, an error occurred when smart configure was being
FF25 Warning
performed.
Description: An error occurred when a smart configure process was being performed on the
server blade in Location X.
Action: Contact your reseller or maintenance personnel.
Message
Description and Action
796