Netm/Remote Control - Hitachi Compute Blade 2000 User Manual

NETM/Remote control

When you use the remote control function, the screen display and mouse operation slow
down due to SVGA emulation. If you do not need to assign USB, do not assign it.
With LPAR manager firmware version 58-7X/78-7X or later, the performance has been
improved as long as the following requirements are satisfied.
Video mode
Text
Graphics
Targeted: Targeted for performance improvement
Not targeted: Not targeted for performance improvement
-: Not supported
Notes on ServerConductor/Blade server
manager
VF NIC view and settings are not supported,

Do not backup configuration information using SC/BSM while the configuration is

being saved on the LPAR manager screen or HVM Navigator, or LPAR migration
is being performed. If you do, the backed up configuration is incomplete. Discard
the back-up obtained during the saving or migration mentioned earlier. Back up
the configuration again after the save or the migration is complete.
It is recommended that you use the following combination of the LPAR manager

firmware version and SC/BSM firmware version.
LPAR manager firmware version
58-30 or later: standard server blades
78-30 or later: high-performance server blades
If you use combinations other than those above, slot numbers are displayed
differently on the LPAR manager screen and SC/BSM as shown below.
USB device/Remote console
Resolution
Assigned
Not targeted
640 x 480 Not targeted
800 x 600 Not targeted
1024 x 768 Not targeted
1280 x 1024 Not targeted
Other than
-
above
1381
LPAR status
Not assigned
Not targeted
Not targeted
Not targeted
Targeted
Not targeted
-
SC/BSM firmware version
09-00 or later