Hitachi Compute Blade 2000 User Manual page 607

Hide thumbs Also See for Compute Blade 2000:

Table of Contents

If you enter S in the switch module setting menu and press Enter, the current switch

module setting is displayed.

(A,N,S,W,[Q]) : S

-- Switch module current network setting --

SW IP address

-- --------------- --------------- ---------------

1.111 255.255.255.

-------------

Hit enter key.

If you enter W in the switch module setting menu and press Enter, the switch module

setting held by the management module is displayed and you are asked to select a

switch module at the prompt.

Enter the slot number of the switch module, and a message to confirm the change is

displayed. At the prompt, enter Y and press Enter, and the switch module setting held

by the management module is applied to the network setting of the switch module. To

cancel the setting change, enter N and press Enter or just press Enter.

(A,N,S,W,[Q]) : W

-- Switch module network setting --

-- ---- ---------------- --------------- --------------- -------- -----------

--------------

--------------

--------------

--------------

--------------

Select switch module (0-5,A=All,[Q=Quit]) : 0

Confirm? (Y,[N]) : Y

- <Switch module0> Writing setting was completed.

Hit enter key.

Default gateway

-------------

Default gateway Ext port Synchronize

255.255.255.

-------------

1.128 MGMT-0

Chapters

Table of Contents