Lpar Manager Setting Item - Hitachi Compute Blade 2000 User Manual

LPAR manager setting item

This section describes setting items when LPAR manager is introduced.
LPAR manager system setting
The following table shows LPAR manager system setting items.
Setting screen & Setting field
Server Blade Web console
LPAR manager setting
EFI
OS mode
LPAR manager
firmware bank number
LPAR manager screen
System configuration
LP IP address
Subnet Mask
Default Gateway
VNIC System No
LP ID
Alert Language
BSM IP address
BSM Alert Port
Virtual Console Port
LPAR manager Operating
Mode
LP CLI IP Address
Date and time
System Time Zone
Display time
TimeSynch
Options
Pre-State Auto Activation
Description for setting field
Set EFI.
Basic or LP mode
Specify an LPAR manager FW bank
number (#0/1)
IP address needed for LPAR
manager-SVP/BSM communication
(IP address for the management segment;
different from the SVP IP address)
Set a unique value to each LPAR manager
system, including Compute Blade 1000,
Compute Blade 2000, and Compute Blade
320.
LPAR manager identifier
The default value created automatically
from the LP IP address is recommended.
Language used for alert notices
Management server address setting, such
as SC and BSM
Port number used in the virtual COM
console
LPAR manager operating modes
Management server address for
commands such as HvmSh and
HvmGetPerf.
SEL time zone in LPAR
Time period for display on the screen
Selection in settings for synchronizing time
with NTP servers.
Restores an LPAR to a state before the
restore if the LPAR is unexpectedly
rebooted.
1419
Default
-
LP mode
0
-
0
LPAR
manager +
IP address
-
-
20801
Standard
0.0.0.0
+ 0 hour
RTC
Disable
No