Basic Operation Of Lpar Manager - Hitachi Compute Blade 2000 User Manual

Basic operation of LPAR manager

This section describes the basic screen settings and operations to boot a guest OS.
LPAR manager screen displays might be different from those in this manual depending on the
LPAR manager firmware version.
Add LPAR and change LPAR name
In the initial state, no LPAR is defined. Follow the procedure below to add LPARs.
1 On the LPAR manager Menu screen, press F6; Add Definition.
2 Select NO_NAME and press Enter. (Place the cursor on 1 and press Enter.)
+------------------------------------------------------------------------------+
|+- Logical Partition(LPAR) +---------------------+---------------------------+|
|| # Name Sta Scd Pro G|
|| 1
|| 2
|| 3
|| 4
|| 5
|| 6
|| 7
|| 8
|| 9
|| 10
||
|+--------------------------| 11 NO_NAME
|+- Logical Information ----| 12 NO_NAME
||
|| Assign Total
|| Act Total
|| Remain
|+--------------------------| 17 NO_NAME
| Logical partition name
+---------------------------| [<-]:Prev/Next:[->] |----------------------------+
| F2:Mem Alloc Dsp F3:Act +---------------------+:Add F7:Remove
+------------------------------------------------------------------------------+
When the number of definable LPARs is 18 or larger, you can
switch the subscreen using arrow keys, [←] or [→]. When the
number of them is 17 or smaller, those arrow keys are not
displayed.
Add LPAR |AC PC VC PB
| |
| 1 NO_NAME |
| 2 NO_NAME |
| 3 NO_NAME |
| 4 NO_NAME |
| 5 NO_NAME |
| 6 NO_NAME |
| 7 NO_NAME |
| 8 NO_NAME |
| 9 NO_NAME |
| 10 NO_NAME | Up / [PageDown]:Page Down ||
|---------------------------+|
| Physical Information -----+|
Pro Shr D| 13 NO_NAME |User Memory
0 0 | 14 NO_NAME |Processors
0 0 | 15 NO_NAME |
| 16 NO_NAME |
|---------------------------+|
+---------------------+
1057
||
||
||
||
||
||
||
||
||
||
||
: 4608 MB ||
: 8(8) ||
Shared : 0 ||
Dedicate : 0 ||
|
Esc:Menu |