Hitachi Compute Blade 2000 User Manual page 1143

 Setting the extensible firmware interface (EFI) driver
Before booting a guest OS, set the EFI driver from EFI Shell. When you have already set
the EFI driver, skip this section.
Make sure to configure to boot a guest OS as follows: booting from a designated disk in
normal operation; booting from the compact disc Read Only Memory (CD-ROM) in OS
installation; Preboot eXecution Environment (PXE) boot (network boot) when using
ServerConductor (SC)/Deployment Manager (DPM).
1 On the screen displayed at the logical BIOS boot, select Boot Maintenance
Manager.
Hitachi Compute Blade E55
Intel(R) Xeon(R) CPU
(IA32.UEFI) Ver: 1.20
Continue
Boot Maintenance Manager
^v=Move Highlight
2 When the Boot Maintenance Manager screen is displayed, select Boot Options.
/------------------------------------------------------------------------------\
|
\------------------------------------------------------------------------------/
Boot Options
Set Time Out Value
Reset System
/------------------------------------------------------------------------------\
|
| ^v=Move Highlight
\------------------------------------------------------------------------------/
LP LPAR
E5504 @ 2.00GHz
<Enter>=Select Entry
Boot Maintenance Manager
Modify system boot
options
<Enter>=Select Entry Esc=Exit without Save
1092
1.99 GHz
This selection will
take you to the Boot
Maintenance Manager
|
|
|