Hitachi Compute Blade 2000 User Manual page 1498

Message content
Explanation An IP address is required for setting the NTP server.
LPAR manager Aborts the time acquisition.
operation
What to do Set an IP address to NTP Server 1 or NTP Server 2.
Message content
Explanation The LPAR cannot be activated.
LPAR manager Aborts LPAR activation.
operation
What to do Check if the LPAR manager system error log is collected. If you cannot
solve the error, contact the reseller from which you purchased this
equipment or consult maintenance personnel.
LPAR activation failed (Insufficient LPAR memory(System
Message content
Explanation Memory size for the LPAR, a value subtracted memory size used by
the system from memory assigned to the LPAR, is not enough.
LPAR manager Aborts LPAR activation.
operation
What to do Assign more memory to the LPAR and then activate the LPAR.
Message content
Explanation Operation is not available due to a failed LPAR by LPAR migration.
LPAR manager Aborts LPAR deactivation.
operation
What to do Remove the failure, and then execute LPAR migration.
Message content
Explanation The LPAR cannot be deactivated.
LPAR manager Aborts LPAR deactivation.
operation
What to do Check if LPAR manager system error log is collected. If you cannot
solve the error, contact the reseller from which you purchased this
equipment or consult maintenance personnel.
Message content
Explanation The target LPAR failed to restart.
LPAR manager Aborts the specified process.
operation
What to do Retry the process.
IP address of NTP server is needed.
LPAR activation failed.
Used:xxMB)).
LPAR corrupted in a LPAR Migration exist,
Please try again after recovering the LPAR.
LPAR deactivation failed.
LPAR start failed.
1447