Hitachi Compute Blade 2000 User Manual page 544

To cancel the setting change of the optimization function, input N after the confirmation
message and press Enter, or just press Enter.
Optimization : Disable
(0=Disable,1=Enable,[Unchange]) : 1 (Enter)
-- Power supply optimization setting --
Optimization : Enable
Confirm? (Y,[N]) : Y (Enter)
- Writing setting was completed.
Hit enter key. (Enter)
If you enter P in the PSM command menu and press Enter, Power cycle count is
displayed.
-- Power cycle count --
PS Count
-- -------
0 0
1 0
2 0
3 114
Hit enter key.
Power cycle count is itemized in the table below.
Item Description of item
Power supply slot
PS
number
Frequency of power
Count supply module on and
off
If you enter A in the PSM command menu and press Enter, you can change the
power supply AC recovery setting. You are requested to select a power supply module,
and the prompt is ready. When you input the number of a power supply, the current
setting values and specifiable values are displayed: the prompt is ready. Just press
Enter or input a setting value and press Enter, and the new setting value is displayed.
A message appears to confirm the settings, and the prompt is ready. Input Y and press
Enter, and the new setting value will be effective. To cancel the setting, input N to the
confirmation message and press Enter or just press Enter.
Value
0 to 3
-
Integer How many times each power supply
module changes from active to
standby.
------- No power supply module is installed
No privilege to display the power
supply module details
493
Description of value