Hitachi Compute Blade 2000 User Manual page 1323

On the Menu screen, press F9: Save Configuration to save the configuration.

|| +----------------------------------------+
|+----------------| LP configuration is saved successfully |----------------+ |
| +-----------------------------------------
-----------------------------------------+
(b) Not using NTP
Check LPAR manager system time on the Date and Time screen. If it is not

the expected one, set the LPAR manager system time zone using F7:
Change System Time Zone.
Check LPAR manager system time on the Date and Time screen. If the

LPAR manager system time is not synchronized, adjust the LPAR manager
system time by F6: Change System Date and Time.
Adjust deactivated LPAR time using Adjust LPAR Time for LPAR System

Time, Specified Zone, and UTC, on the Date and Time screen. Check the
guest OS time zone, and perform Adjust LPAR Time with the same time zone
as the guest OS. For activated LPARs, adjust the time by using the guest OS
or NTP time synchronization for the guest OS.
Enable the Save Time Config on the Options screen.

Save the configuration on the Menu screen using F9: Save Configuration.

With LPAR manager firmware version 59-41/79-41 or later,
enabling "Save Time Config" is recommended. You can
change settings for "Save Time Config" while LPAR manager
is running.
If you reboot LPAR manager after operating it for a long time
with "Save Time Config" disabled, or if a system failure in
LPAR manager or failover with N+M cold standby
unexpectedly occurs, a time lag occurs in the guest OS.
If changing LPAR manager configuration or LPAR
configuration with "Save Time Config" enabled, make sure to
press the F9 key at the end of the setting change. Although
LPAR manager configuration is saved at time adjustment with
"Save Time Config" enabled, the timing cannot be specified.
When LPAR manager configuration is saved at time
adjustment, LPAR manager screen appears; system event
logs are collected; the alert is notified. Those operations can
be prevented by disabling "Save Time Config".
<LPAR manager screen>
| +------------------------------+
|+----------------------| Saving LP configuration ... |---------------------+ |
| +------------------------------+
1272
| |
|
| |
| |
|