Initial Installation Operation Overview - Hitachi Compute Blade 2000 User Manual

Initial installation operation overview

This section outlines required operations at initial installation.
For details on the operations, see the following sections.
The operations below are indispensable during initial
installation. For details about operations after the initial
installation, see the manual described in "Details on how to
operate the system."
1 Login.
Log in to the system. Use user ID "operator" set during initial installation.
("operator" is not assigned any passwords and, therefore, you can log in to the
system without authentication.)
2
Setting the system administrator's password.
Set the system administrator's password, which is not initially set. To prevent
security deterioration, set that password.
3 Adding a user ID and deleting "operator".
Create a new user ID.
When not using login user "operator" set during initial installation as the qualified
login user, you should delete it after a new login user created by the rmuser
command to prevent security deterioration.
Login
Starting the system, you will see the login prompt appear. Following the login prompt,
enter the user ID to log in to the system.
login: operator ...Enter user ID "operator".
Copyright (c) 2005-2009 ALAXALA Networks Corporation. All rights reserved.
>
In the following descriptions, information might be different
depending on the software version. Basic operations,
however, are unchanged.
807