Hitachi Compute Blade 2000 User Manual page 1200

 Serial setting when using the guest screen
When using a guest screen, execute the following serial settings. When you have done
the serial settings, skip these settings.
Windows Server 2003 R2
1 Execute the following command from the command prompt.
bootcfg /ems EDIT /port COM1
bootcfg /ems ON /baud 115200 /id 1
Windows Server 2008/Windows Server 2008 R2/Windows Server 2012/Windows
Server 2012 R2
1 Execute the following command from the command prompt.
bcdedit/ems ON
bcdedit/emssettings EMSPORT:1 EMSBAUDRATE:115200
Red Hat Enterprise Linux 5
1 /boot/grub/grub.conf setting
1) Comment out the line "spashimage=(hd0,0)/grub/splash.xpm.gz".
2) Add the following two lines between lines of hiddenmenu and title.
"serial --unit=0 --speed= 115200
"terminal --timeout=10 serial console".
3) Add the following line at the end of the kernel line.
"console=tty0 console=ttyS0,115200"
2 /etc/sysconfig/init setting
Change "BOOTUP=color" to "BOOTUP=serial".
3 /etc/sysconfig/kudzu setting
Change "SAFE=no" to "SAFE=yes".
4 /etc/inittab setting
Add "co:2345:respawn]/sbin/agetty 115200 ttyS0vt100" to the bottom line.
5 /etc/securetty setting
1) Add ttyS0 at the bottom line.
Red Hat Enterprise Linux 6
1 /boot/grub/grub.conf setting
1) Comment out the line "spashimage=(hd0,0)/grub/splash.xpm.gz".
2) Add the following two lines between lines of hiddenmenu and title.
serial --unit=0 --speed= 115200
terminal –timeout=10 serial console".
3) Add the following line at the end of the kernel line.
console=ttyS0,15200" .
2 /etc/sysconfig/init setting
Change "BOOTUP=color" to "BOOTUP=serial".
1149