Installing The Spm Software - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance

Installing the SPM Software

NOTE:
SPM uses Interrupt 4 and I/O address 3F8 for COM1. It uses Interrupt 3
and I/O address 2F8 for COM2.
Installing the SPM Software
Before you install or run SPM, use
system guide) to make a backup copy of the SPM diskette and store the
original in a safe place. Use the backup copy to run the installation program.
For installing SPM on a DOS PC, follow the appropriate instructions in the next
section of this book.
NOTE:
If your PC does not have a hard disk, you do not need to run the
installation program. Go to "Initializing the SPM Software."
DOS Installation
Use the following procedure to install SPM on the hard drive of a DOS PC.
NOTE:
If you are updating SPM, you do not need to remove the current SPM
files. The new files will overwrite your current SPM files.
Considerations
Review the following items before you begin the installation procedure.
The installation program automatically performs the following:
Checks available space on the hard disk. If space is insufficient, the
installation is terminated and an error message is generated.
on a DOS PC (see your operating
Issue 1
February 1998
Page 4