Replace The Avaya S8800 Server; Reuse Of Hardware Components In Replacement Servers; Required Equipment And Tools; Interchanging And Busying Out The Server - Avaya S8800 Manual

Hide thumbs Also See for S8800:

Table of Contents

Replace the Avaya S8800 Server and its components

Replace the Avaya S8800 Server

When you replace the Avaya S8800 Server, you must reuse the following components:

• DIMMs (4 GB capacity)

• Redundant power supply if used

• PCIe card (dual NIC populated in slot 1 of the server)

• Two hard disk drives

The requirements are as follows:

• Replacement Avaya S8800 Server

The comcode of the replacement Communication Manager S8800 1U Server is

700478522.

• #2 cross-point (Phillips) screwdriver or 3/8 inch flathead screwdriver

• USB keyboard, USB mouse, and monitor

• Electrostatic wrist ground strap and mat

Important:

The replacement server is not shipped with the dual NIC PCI board and redundant power

supply (if used). When you replace the Avaya S8800 Server, you must reuse these

components in the replacement server. If any of these components are not functional in the

failed server, you must order for them as separate items.

About this task

Important:

You must interchange and busy out the server only if you are replacing the Avaya S8800

Server with a duplex configuration. If you are replacing the Avaya S8800 Server with a

simplex configuration, skip this task.

Maintaining the Avaya S8800 Server for Avaya Aura

Communication Manager

Comments? infodev@avaya.com

July 2012

Table of Contents