Mpls Ldp Neighbor Information - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in MPLS LDP Neighbor Targeted Settings are described below:
Parameter
Neighbor Targeted
Targeted Hello Interval
Targeted Hello Hold Time
Click the Apply button to accept the changes made.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

MPLS LDP Neighbor Information

This window is used to view and clear the MPLS feature's LDP neighbor information
To view the following window, click MPLS > MPLS LDP Neighbor Information, as shown below:
The fields that can be configured in MPLS LDP Neighbor Information are described below:
Parameter
Peer
Click the Find button to locate a specific entry based on the information entered.
Click the Clear button to clear the entries based on the information entered.
Click the Clear All button to clear the information associated with all entries.
Figure 11-5 MPLS LDP Neighbor Targeted Settings Window
Description
Enter the LSR ID of the targeted peer here. The targeted peer is used
to establish the LDP session with the non-directly connected neighbor.
Enter the interval to the hello message for sessions with extended
peers here. The range is from 5 to 65535 seconds. Select the Default
option to use the default value, which is 15 seconds.
Enter the hold-time of the hello messages for sessions with extended
peers here. The range is from 15 to 65535 seconds. Select the Default
option to use the default value, which is 45 seconds.
Figure 11-6 MPLS LDP Neighbor Information Window
Description
Enter the IP address which is used as the peer LSR ID here.
570