Lldp Port Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in LLDP-MED Settings are described below:
Parameter
Fast Start Repeat Count
Click the Apply button to accept the changes made.
The fields that can be configured in LLDP Configurations are described below:
Parameter
Message TX Interval
Message TX Hold Multiplier
ReInit Delay
TX Delay
Click the Apply button to accept the changes made.

LLDP Port Settings

This window is used to view and configure the LLDP port settings.
To view the following window, click L2 Features > LLDP > LLDP Port Settings, as shown below:
The fields that can be configured in LLDP Port Settings are described below:
Parameter
Unit
From Port ~ To Port
Description
Enter the LLDP-MED fast start repeat count value. This value must be
between 1 and 10.
Description
Enter the interval between consecutive transmissions of LLDP
advertisements on each physical interface. The range is from 5 to
32768 seconds.
Enter the multiplier on the LLDPDUs transmission interval that used to
compute the TTL value of an LLDPDU. This value must be between 2
and 10.
Enter the delay value for LLDP initialization on an interface. This value
must be between 1 and 10 seconds.
Enter the delay value for sending successive LLDPDUs on an
interface. The valid values are from 1 to 8192 seconds and should not
be greater than one-fourth of the transmission interval timer.
Figure 5-73 LLDP Port Settings Window
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
159