D-Link DXS-3600 Series Reference Manual page 595

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Click the Apply button to accept the changes made.
Click the Edit button to modify the specified entry.
Click the Show Detail button to view more detailed information about the entry.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear.
The fields that can be configured in VPLS Settings are described below:
Parameter
VPLS ID
PW Type
MTU
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
The fields that can be configured in Neighbor Settings are described below:
Parameter
Remote Peer
VC ID
Figure 12-6 VPLS Settings (Edit) Window
Description
Select and enter the VPLS instance's ID here. The range is from 1 to
4294967295.
Select the PW type here. Options to choose from are Raw and
Tagged.
•
Raw: Specifies that the service type is in the Ethernet-raw mode.
It means that the encapsulation of all PWs in the VPLS is in the
Ethernet-raw mode.
•
Tagged: Specifies that the service type is in the Ethernet-tagged
mode. It means that the encapsulation of all PWs in the VPLS is
in the Ethernet-tagged mode.
Select and enter the local AC link's MTU value of a VPLS that will be
advertised to remote peers in this VPLS here. The MTU value must be
same at both the local and remote sites to establish the PW. If the
MTU is specified as 0, then local the MTU will not be advertised to
remote peers in the VPLS. The range is from 0 to 65535 bytes. By
default, this value is 1500 bytes.
Description
Enter the LSR ID that is used to identify the PE to which the peer
belongs to here.
Enter the PW's VC ID here. The range is from 1 to 4294967295. It is
used with the IP address to uniquely identify a peer for a VPLS. If not
specified, the PW ID is set by the VPN ID of this VPLS.
584