Ets Recommend Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in ETS Port Settings are described below:
Parameter
Unit
From Port ~ To Port
ETS Willing
Click the Apply button to accept the changes made.
Click the Admin Info button to view ETS administrative information associated with the port.
Click the Operational Info button to view ETS operational information associated with the port.
After clicking the Admin Info button, the following page will appear.

ETS Recommend Settings

This window is used to view and configure the ETS recommended settings on the specified interface.
These settings will be translated to a DCBX ETS recommendation TLV. The TLV is encoded into each
LLDP message and may be transmitted by a system in order to indicate a recommendation on how ETS
should be configured.
To view the following window, click QoS > ETS > ETS Recommended Settings, as shown below:
Description
Select the switch's unit ID that will be used here.
Select the switch's port range that will be used here.
Select to enable or disable the ETS willing mode for DCBX on the
specified port(s). This indicates that the interface is willing to accept
configurations from the remote switch. DCBX is used by DCB devices
to exchange configuration information with directly connected peers.
The protocol may also be used for misconfiguration detection and for
configuration of the peer. The willing mode indicates that the local port
has been administratively configured to accept configurations from the
remote device.
Figure 7-27 ETS Port Settings (Admin Info) Window
341