D-Link DXS-3600 Series Reference Manual page 267

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
BSR Domain Border
PIM Passive Mode
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
PIM for IPv6 BSR Candidate Settings
This window is used to view and configure the IPv6 PIM BSR candidate settings. This feature only affects
PIM-SM operation. This will cause the router to send bootstrap messages to all its PIM neighbors, with
the address of the designated interface as the BSR address. A PIM-SM domain must contain a unique
BSR (Bootstrap Router) which is responsible for collect and advertise the RP information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6
> PIM for IPv6 BSR Candidate Settings, as shown below:
The fields that can be configured in BSR Candidate Settings are described below:
Parameter
Interface Name
Hash Mask Length
Description
For SM-mode, the router will periodically send the join message based
on this interval. The hold-time in a Join/Prune message is 3.5 times the
join-prune-interval. The receiving router will start a timer based on this
hold-time, and prune the interface if no join message is received on
this interface. Select the Default option to use the default value, which
is 60 seconds.
Select to enable or disable the BSR domain border feature here. When
an interface is configured as a border, it will prevent bootstrap router
(BSR) messages from being sent or received through it.
Select to enable or disable the PIM passive mode for this interface
here. This feature only takes effect when the interface is IPv6 PIM
enabled. When the passive mode is enabled, the interface will neither
send PIM messages out nor accept PIM messages from this interface.
The router will act as it is the only PIM router on the network. Use this
feature only when there is only one PIM router on the LAN.
Figure 6-118 PIM for IPv6 BSR Candidate Settings Window
Description
Enter the VLAN interface's name used here.
Enter the hash mask length for RP selection here. The range is from 0
to 128. The mask (128 bits maximum) that is to be logically AND with
the group address before the hash function is executed. All groups
256