D-Link DXS-3600 Series Reference Manual page 273

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Source
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
PIM for IPv6 Register Settings
This window is used to view and configure the IPv6 PIM register settings.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6
> PIM for IPv6 Register Settings, as shown below:
The fields that can be configured in Register Checksum Wholepkt are described below:
Parameter
Register Checksum Wholepkt
Click the Apply button to accept the changes made.
The fields that can be configured in Register Probe Time are described below:
Parameter
Register Probe
Click the Apply button to accept the changes made.
The fields that can be configured in Register Suppression Time are described below:
Description
Select the source to display here. Options to choose from are
Bootstrap, Embedded RP, and Static.
•
Bootstrap: Specifies to display ranges learned through the BSR.
•
Embedded RP: Specifies to display group ranges learned
through the embedded rendezvous point (RP).
•
Static: Specifies to display ranges enabled by static
configuration.
Figure 6-127 PIM for IPv6 Register Settings Window
Description
Select the enable or disable the register checksum whole-packet
feature here. When enabled, it configures the router to calculate the
checksum of register message over the entire PIM message including
the data portion. By default, the register checksum methodology is PIM
RFC-compliant, excluding the data portion in the Register message.
Description
Enter the register probe time value here. The range is from 1 to 127
seconds. The register-probe time is the time before the Register-Stop
Timer (RST) expires when a DR may send a Null-Register to the RP to
cause it to resend a Register-Stop message. Select the Default option
to use the default value, which is 5 seconds.
262